首站-论文投稿智能助手
典型文献
Erosion-corrosion resistance of Mo-Ti-and Ni-Cr-Mo-alloyed medium-carbon martensitic steels:a critical analysis of synergistic effect of erosion and corrosion
文献摘要:
Grain refinement renders Mo-Ti-alloyed medium-carbon martensitic steel to exhibit high hardness,high strength,and good toughness,but the erosion-corrosion resistance of steel in a corrosive slurry environment is not known.Mo-Ti-alloyed medium-carbon martensitic steel is compared with Ni-Cr-Mo-alloyed medium-carbon martensitic steel,and the erosion-corrosion resistance of those two steels under impingement by NaCl solution with gravels has been investigated.Three components,pure-corrosion rate,pure-erosion rate,and synergistic effect of erosion and corrosion(SEEC)of erosion-corrosion rate,were quantified.The pure-corrosion and pure-erosion rates of Mo-Ti-alloyed steel were higher than those of Ni-Cr-Mo-alloyed one;however,its erosion-corrosion rate was relatively lower because of a weak SEEC.Surface plastic deformation and work hardening due to gravel impingement were the essential reason for SEEC,which could be reduced by grain refinement,and consequently,Mo-Ti-alloyed steel with finer grains had better erosion-corrosion resistance.Grain refinement could be an effective way to improve the erosion-corrosion resistance of martensitic steels.
文献关键词:
作者姓名:
De-fa Li;Hang-yu Dong;Cheng-yang Hu;Kai-ming Wu;Serhii Yershov;Oleg Isayev
作者机构:
School of Mechanical and Vehicle Engineering,West Anhui University,Luan 237012,Anhui,China;The State Key Laboratory of Refractories and Metallurgy,Hubei Province Key Laboratory of Systems Science on Metallurgical Processing,International Research Institute for Steel Technology,Wuhan University of Science and Technology,Wuhan 430081,Hubei,China;Laboratory for Excellence in Advanced Steel Research,Materials Science and Engineering Program,Department of Metallurgical,Materials and Biomedical Engineering,University of Texas at El Paso,El Paso,TX 79968,USA
引用格式:
[1]De-fa Li;Hang-yu Dong;Cheng-yang Hu;Kai-ming Wu;Serhii Yershov;Oleg Isayev-.Erosion-corrosion resistance of Mo-Ti-and Ni-Cr-Mo-alloyed medium-carbon martensitic steels:a critical analysis of synergistic effect of erosion and corrosion)[J].钢铁研究学报(英文版),2022(08):1299-1311
A类:
gravels
B类:
Erosion,corrosion,resistance,Mo,Ti,alloyed,medium,carbon,martensitic,steels,critical,analysis,synergistic,erosion,Grain,refinement,renders,exhibit,hardness,strength,good,toughness,but,corrosive,slurry,environment,not,known,compared,those,two,under,impingement,by,NaCl,solution,has,been,investigated,Three,components,pure,SEEC,were,quantified,rates,higher,than,however,its,was,relatively,lower,because,weak,Surface,plastic,deformation,work,hardening,due,essential,reason,which,could,reduced,consequently,finer,grains,had,better,effective,way,improve
AB值:
0.395112
相似文献
Influence of Zr and Mn additions on microstructure and properties of Mg–2.5wt%Cu–Xwt%Zn (X = 2.5, 5 and 6.5) alloys
A.V.Koltygin;V.E.Bazhenov;I.V.Plisetskaya;V.A.Bautin;A.I.Bazlov;N.Y.Tabachkova;O.O.Voropaeva;A.A.Komissarov;V.D.Belov-Foundry Department,National University of Science and Technology(MISiS),Moscow 119049,Russia;Department of Metallurgy Steel,New Production Technologies and Protection of Metals,National University of Science and Technology(MISiS),Moscow119049,Russia;Laboratory of Advanced Green Materials,National University of Science and Technology(MISiS),Moscow 119049,Russia;Department of Materials Science of Semiconductors and Dielectrics,National University of Science and Technology(MISiS),Moscow 119049,Russia;Fianit Laboratory(Laser Materials and Technology Research Center at GPI),Prokhorov General Physics Institute RAS,Moscow 119991,Russia;Laboratory of Hybrid Nanostructured Materials,National University of Science and Technology(MISiS),Moscow 119049,Russia;Laboratory of Medical Bioresorption and Bioresistance,Moscow State University of Medicine and Dentistry,Moscow 127473,Russia
Medium-entropy(Me,Ti)0.1(Zr,Hf,Ce)0.9O2(Me=Y and Ta):Promising thermal barrier materials for high-temperature thermal radiation shielding and CMAS blocking
Shuaihang Qiu;Huimin Xiang;Fu-Zhi Dai;Hailong Wang;Muzhang Huang;Chunlei Wan;Qing Meng;Jiangtao Li;Xiaohui Wang;Yanchun Zhou-Science and Technology on Advanced Functional Composite Laboratory,Aerospace Research Institute of Materials and Processing Technology,Beijing 100076,China;State Key Laboratory of Advanced Technology for Materials Synthesis and Processing,Wuhan University of Technology,Wuhan 430070,China;School of Materials Science and Engineering,Zhengzhou University,Zhengzhou 450001,China;State Key Lab of New Ceramics and Fine Processing,School of Materials Science and Engineering,Tsinghua University,Beijing 100084,China;Technical Institute of Physics and Chemistry,Chinese Academy of Sciences,Beijing 100190,China;Institute of Metal Research,Chinese Academy of Sciences,Shenyang 110016,China
机标中图分类号,由域田数据科技根据网络公开资料自动分析生成,仅供学习研究参考。